12v, 105A, Neg Grnd
Our alternators are imported copies of the Cs130 pictured here. It is the perfect replacement for your Lucas equipped Classic Vehicle. Comes with v-belt pulley and correct electrical plug. Serpentine pulley available on request, as well as other repair and replacement parts. Internally regulated at 14.6v. See specs below for more detail.
These alternators are ready to install. Just follow the directions.
Charge your battery before installation of the Alternator.
Failure to do so WILL shorten the life of your alternator.
In the event your unit does not work
1) Recheck your connections.
2) Make sure a good Dash Alternator light bulb is in the circuit
NO DASH ALTERNATOR LIGHT= NO CHARGING
Please Note! It may be necessary to reverse the large bushing on the mounting ear in order to fit properly.
Additionally, Check the clearance between the lower alternator adjusting arm and the alternator fan to make sure there is no binding after the install. If not slide the lower arm off it’s post and cut or grind about ¼ inch of material to get the proper clearance from the fan. If your belt doesn’t fit see your local auto parts store and take your old belt with you. They will be able to fit you up with the right size belt. MGC required Napa #25-9420. A narrower number is 25-7410.
Wiring: You will only need to do some simple wiring.
1.) Remove the Lucas plug
2.) Using eyelets (provided) attach Large and Small Solid Brown wires from the starter along with the Large Red wire (S) on the new plug, to the battery post on the alternator.
3.) Connect the Small Brown (L) on the new plugto the Brown with yellow tracer from the wire harness (this is the alternator light on the dash and must be in good working order). (Provided are 1/4 inch male/female spade connectors.)
4.) The remaining Brown wire (F) and Gray wire (P) on the new plug, can be cut off If desired.
Please charge your battery before installation of the Alternator.
Note: Bushing may need to be reversed to fit and acquire better alignment.
Generator to Alternator Conversion Tips by Barney Gaylord
Posted by Ralph on Sep 9th 2017
My 71 BGT w/ AC had a new 65 amp alternator unfortunately it could not keep up. With the AC on the ignition light would dimly glow. Switched to the upgraded CS 105 amp alternator and works perfectly. Easy installation w/ good instruction.
CS130 made in CHINA
Posted by Frank Weeks on Jan 22nd 2017
I was very disappointed to see the made in china sticker on the plain white box. I would probably been better off just buying a Lucas alternator. I was trying to up the quality w/ the US Delco over the Lucas, so much for that. I also believed that it came with a larger dia. pulley but it didn't.
Sorry you were disappointed, You may find it a hassel but you are welcome to send it back for a refund.
Posted by Bob Finley on Jan 9th 2017
The CS-130 alternator is one of the best upgrades we can do for our Lucas equipped LBCs. My order for the alternator was processed quickly and I found it to be professionally packaged and the instructions were easy to follow. I installed on a late model RB MGB and I did need one trip to the hardware store to complete the install. Late model MGBs have two large solid brown wires (vice the large and small mentioned in the instructions) and they will not fit in the eyelet provided - you need two of them. All in all, this is a real easy installation and the alternator is a huge improvement over the Lucas that it replaces.
Posted by Brian on Oct 15th 2016
Fitted to my 1972 Mini. I was not expecting it to fit without a lot of monkeying around and maybe even some fabrication of some sort. Wrong. It fit perfectly, almost. I did have to grind a bit off the stock adjusting bracket - not a big deal at all. Instructions were clear and didn't have to deviate from them at all. It puts out a rock solid 14.7 volts. I can turn on every auxiliary at idle and the voltmeter barely moves and recovers quickly. Great service. Would certainly recommend!
Posted by Matt on Sep 25th 2016
Replace failing alternator in 72 MGB. Perfect fit, good instruction and answered questions quickly. Even includes quality heat shrink connectors.
Posted by David Cohen on Aug 16th 2016
My order for the alternator was processed promptly and shipped. Upon receiving it I found it to be professionally packaged with clear instructions. I would definitely order other products they provide as needed.
Posted by Unknown on Jun 15th 2016
Instructions are very clear which makes installation easy. Having the pulley installed and the alternator body already set up is great. This was installed in a 1974 MGB (chrome bumper) with the Moss air conditioner. It fits perfectly. The only alteration I had to make was to shorten the adjuster bracket.
Solid Upgrade for MGB
Posted by Tom on Jun 2nd 2016
The improvement over the 43 amp unit is remarkable.Solid Kit.
I do recommend adding one more of the yellow crimps. It comes with 2. But I like to keep my wires individualized. I had some around, but not every one will. The MG actually has lights now.
Continuing Great Customer Service!
Posted by Terry Jones on May 31st 2016
great product, very well thought out, very customer friendly to install, a wise addition to your classic B,
and as always backed up by Ed's willingness to help!